Each shot was taken on various points of the speaker in a pseudo DynaCab™ fashion and how I go about micing cabs in the studio. I fine tune the low end to my taste with the distance from the speaker, then File Numbers 01, 02, 03...etc. are the microphones speaker position from the cone to edge for high end brightest to darkest.
For the “Standard Ribbon/Dynamic Mic Combo” use a “…07.wav” file mixed with the “…CLOSE_CENTER.wav” of the Ribbon Mic captures.
The “Room” captures are at ear height sitting in a chair about 6 feet from the cab. Panned left and right is a nice room effect.
MICS
Dynamic:
57m - Based on a modified modern Shure™ SM57
UIII - Based on a vintage Shure® Unidyne III SM57
M88 - Based on Beyerdynamic™ M88
Ribbon:
VR2 - Based on sE Electronics™ VR2
121 - Based on a Royer™ R-121
Condenser:
CC8 - Based on Austrian Audio™ CC8
Which files to use:
All captures are 24bit 500ms MPT (Minimum Phase Transformed) format that is phase aligned with most modelers’ user cabinets. This Cab Pack is compatible with all modelers and IR loaders that support .wav format IR’s. Hardware units that require shorter files will automatically truncate 500ms files to the unit’s preferred length upon import.
Please refer to your hardware unit’s manual to determine which sample rate is right for and how to load them into your particular system.
48k - For use with Fractal™, Line 6™, Boss™, and most modeling units.
44.1k - For use with Kemper™ units.
96k - For use with Strymon™ Iridium.